Everything You Need To Know About Your Beaker Ultimate

Welcome to the cleaning hub for your Freeze Pipe gear! Our Freeze Pipe Cleaning Solution is specially formulated to keep your glass spotless. Why compromise when you can have the best? Get the ultimate clean here!

🧼 Cleaning

📃 What You Will Need:

Any store bought or homemade glass cleaning solution. To make your own cleaning solution simply mix Coarse Sea Salt and 99% isopropyl (rubbing alcohol)

🥶 Cleaning Glycerin Downstem

Step 1 - Place the pipe into a large zip lock bag.

Step 2 - Pour in alcohol and salt making sure to soak the inside and outside of the pipe.

Step 3 - GENTLY shake the bag to spread the solution around the pipe.

Step 4 - Repeat this until the inside of the coil is cleared.

Step 5 - Rinse thoroughly with room temperature water and LET DRY before using/ placing in the freezer.

🧊 Cleaning Glycerin Coil:

Step 1 - Plug the bottom of the coil with a rubber stopper or a rolled up napkin.

Step 2 - Pour in alcohol and salt filling the coil a third of the way up.

Step 3 - Plug the top of the coil with either a rubber stopper or napkin.

Step 4 - GENTLY shake to spread the solution around the coil until the inside is cleared.

Step 5 - Remove plugs and rinse thoroughly with room temperature water and LET DRY before using/ placing in the freezer.

Alternatively - Place the coil into a large zip lock bag and submerge coil with solution. GENTLY shake and tilt the bag so solution runs through the coil. Repeat this until the inside of the coil looks clean. For heavier cleans you can let soak for 10 - 15 mins. Rinse thoroughly and let dry.

💦 Cleaning Base:

Step 1 - Empty out the old water from the base.

Step 2 - Pour in alcohol and salt filling the base about a quarter of the way up.

Step 3 - Plug both ends of the base with a rubber stopper or a rolled up napkin.

Step 4 - GENTLY shake the base to spread around the solution and repeat this until cleared.

Step 5 - Remove plugs and rinse thoroughly with warm water and dry before usage.

* This method can be used for any of the glycerin chambers from our bubblers, bong, recyclers, the original Freeze Pipe and any of the bowls for all our products.

🏗 Assembly

📎 Putting The Clips On:

The big side of clip goes towards the base, the small side faces the glycerin coil.

For the UFO perc the big side of the clip goes towards the bottom, the smaller faces up.

💧 Water Fill Levels:

Fill the base about half way with water. Goal is half-inch to an inch of water above the slits in the downstem.

🤔 FAQs

How Long Do I Freeze The Glycerin Chamber and Glycerin Downstem For?

1-hour is all you need. But you can leave the chamber in the freezer in between sessions.

What Coils Fit On To The Beaker Ultimate

Original spiral coil, revolver coil, XL spiral, XL revolver, Straight coil and DNA Coil.

What's The Safest Way To Put The Clip On?

The best way to put the clip on is to support the back of the joint with your hand and push the clip into place.

Can I clean it with hot water?

NO! The best method is to use either our solution or salt and alcohol solution to clean your piece. Hot water can cause damage to the glass and potentially cause breakage.

📈 Recommended Beaker Ultimate Accessories

❄️ Shop By Category