Everything You Need To Know About Your Bong Dual
🧼 Cleaning
📃 What You Will Need:
Any store bought or homemade glass cleaning solution. To make your own cleaning solution simply mix Coarse Sea Salt and 99% isopropyl (rubbing alcohol)
🧊 Cleaning Glycerin Coil:
Step 1 - Plug the bottom of the coil with a rubber stopper or a rolled up napkin.
Step 2 - Pour in alcohol and salt filling the coil a third of the way up.
Step 3 - Plug the top of the coil with either a rubber stopper or napkin.
Step 4 - GENTLY shake to spread the solution around the coil until the inside is cleared.
Step 5 - Remove plugs and rinse thoroughly with room temperature water and LET DRY before using/ placing in the freezer.
👽 Cleaning UFO Base:
Step 1 - Empty the water from the piece.
Step 2 - Plug the bottom of the tube with a rubber stopper or a rolled up napkin.
Step 3 - Fill the tube about a quarter of the way up with alcohol and salt and plug the top of the tube.
Step 4 - GENTLY shake to spread the solution around the tube until the inside is cleared.
Step 5 - Remove plugs and rinse thoroughly with room temperature water and dry before usage.
💦 Cleaning Base:
Step 1 - Empty out the old water from the base.
Step 2 - Pour in alcohol and salt filling the base about a quarter of the way up.
Step 3 - Plug both ends of the base with a rubber stopper or a rolled up napkin.
Step 4 - GENTLY shake the base to spread around the solution and repeat this until cleared.
Step 5 - Remove plugs and rinse thoroughly with warm water and dry before usage.
* This method can be used for any of the glycerin chambers from our bubblers, bong, recyclers, the original Freeze Pipe and any of the bowls for all our products.
Using The Freeze Pipe Cleaning Kit
Step-by-step Cleaning Instructions - Great For Beginners
🏗 Assembly
Click Below For Quick Video Instructions
📎 Putting The Clips On:
The big side of clip goes towards the base, the small side faces the glycerin coil.
For the UFO perc the big side of the clip goes towards the bottom, the smaller faces up.
💧 Water Fill Levels
Fill the base and UFO Perc just enough so the tops of the percolators (the slits) are submerged with water. You can always do a test run before lighting. If no bubbles, add water, if you feel too much drag remove water.
🤔 FAQs
How Long Do I Freeze The Glycerin Chamber For?
1-hour is all you need. But you can leave the chamber in the freezer in between sessions.