How To Clean Your Piece With The Freeze Pipe Cleaning Kit
Don't have the Freeze Pipe Cleaning Kit? Click Here for standard instructions.
Step 1 - Place rubber cap on one end of the glycerin coil, pour cleaning solution into coil and place another cap on opposite end.
Step 2 - Shake and tilt glycerin coil back-and-forth for 5 minutes. Make sure solution passes through each end of the coil multiple times.
Step 3 - Place the coil down and let the solution marinate inside the piece for 5 minutes.
Step 4 - Repeat step-2 for one minute.
Step 5 - Rinse thoroughly with warm water and LET DRY before using/ placing in the freezer
* This method can be used for any of the glycerin coils on our bubblers, bongs, and recyclers
* The use of a cap or plug is subjective. If you feel more comfortable using a plug, that's okay. The goal is to create a seal that cleaning solution won't leak out of.
How Do I Clean The Base?
* Make sure to remove all bong water, downstems and bowls before cleaning
Step 1 - Fill the base so the percs are submerged in cleaning solution. Then use plugs and/or caps to cover the top of the base and downstem.
Step 2 - Shake the base so the cleaning solution runs through the percolators and visibly dirty areas.
Shake up-and-down and then side-to-side, depending on the area you are trying to clean. If using a plug you may want to keep your finger on the plug for support. For dirtier bongs, feel free to add more solution or warm water. If there's a specific troublesome spot focus on that area and make sure the solution runs across it multiple times.
Step 3 - Place the base down and let the solution marinate inside the piece for 5 minutes.
Step 4 - Repeat step-2 for one minute.
Step 5 - Ring thoroughly with warm water
Lightly shake the bong as the warm water is entering and leaving the base.
Other Products You May Like
Beaker Bong $139.95
Bubbler $109.95
Bong Dual $249.95
Dab Rigs & Recyclers