Welcome to the cleaning hub for your Freeze Pipe gear! Our Freeze Pipe Cleaning Solution is specially formulated to keep your glass spotless. Why compromise when you can have the best? Get the ultimate clean here!

📃 What You Will Need:

Any store bought or homemade glass cleaning solution. To make your own cleaning solution simply mix Coarse Sea Salt and 99% isopropyl (rubbing alcohol)

🧊 Cleaning Glycerin Coil:

Step 1 - Plug the bottom of the coil with a rubber stopper or a rolled up napkin.

Step 2 - Pour in alcohol and salt filling the coil a third of the way up.

Step 3 - Plug the top of the coil with either a rubber stopper or napkin.

Step 4 - GENTLY shake to spread the solution around the coil until the inside is cleared.

Step 5 - Remove plugs and rinse thoroughly with room temperature water and LET DRY before using/ placing in the freezer.

Alternatively - Place coil in ziplock bag and fill big with solution so coil is mostly submerged. Let sit for 5-10 then tilt back and forth so solution runs from end-to-end. Rinse thoroughly and let dry.

💦 Cleaning Base:

Step 1 - Empty out the old water from the base.

Step 2 - Pour in alcohol and salt filling the base about a third of the way up.

Step 3 - Plug both ends of the base with a rubber stopper or a rolled up napkin.

Step 4 - GENTLY shake the base to spread around the solution and repeat this until cleared.

Step 5 - Remove plugs and rinse thoroughly with warm water and dry before usage.

* This method can be used for any of the glycerin chambers from our bubblers, bong, recyclers, the original Freeze Pipe and any of the bowls for all our products.

How Long Do I Freeze The Glycerin Chamber For?

1-hour is all you need. But you can leave the chamber in the freezer in between sessions.

What Coils Fit On To The Bubbler?

The bubbler fits the original spiral coil and the bubbler revolver coil.

Should I Freeze The Whole Unit?

Only the coil should be frozen as water could expand in the base causing it to crack.

What's The Safest Way To Put The Clip On?

The best way to put the clip on is to support the back of the joint with your hand and push the clip into place.

Can I clean it with hot water?

NO! The best method is to use either our solution or salt and alcohol solution to clean your piece. Hot water can cause damage to the glass and potentially cause breakage.

Putting The Clips On:

The big side of clip goes towards the glycerin chamber, the small side faces the base.

Water Fill Levels:

Fill the base just enough so the tops of the percolators (the slits in the tree arms) are submerged with water. You can always do a test run before lighting. If no bubbles, add water, if you feel too much drag remove water.

❄️ Shop By Category: